The best place to start when you are doing a renovation is to make your home as air tight as possible. In an existing home this means looking at the attic first. Most people assume windows and doors are the largest air leaks and energy leaks, but typically it is the attic. Focusing on stopping the heat from rising out of your home (In summer, running your air conditioner cools the house, creating a temperature imbalance that pulls hot, humid attic air down through those same ceiling gaps) will reduce the remainder of the air leaks.
Stack effect is the rise of warm moist air inside of a home that pushes against the top ceiling while pulling in air from low points. This causes a pressure difference inside the home that naturally occurs causing air movement and increases air leakage. When doing energy retrofit in a home that has combustion appliances, be sure that each appliance has proper combustion air before starting this work.
The attic floor is 60 to 70% of your leakage into this space. Warm air naturally rises due to the stack effect, driving warm, conditioned air upward to the attic and through the vents. This creates a vacuum type effect that pulls in unconditioned air through all the other leaks in your thermal envelope. Key areas to seal include:
- Attic Hatch or Drop Down Stair – this is often a big hole straight into living space and often with no insulation above.
- Plumbing and electrical chases – areas where wires penetrate the drywall / plaster ceiling that run into interior walls are open chases to energy to escape.
- Recessed can lights – these are large holes in the ceiling with no air sealing. If the budget doesn’t allow for replacing old recessed can lights with new fire rated and air sealed cans, then you can use fire-rated rigid foam boxes over them and caulk them tight to the drywall below.
- Top plates – hard to get to these in an existing house, so it depends on the level of renovation you are doing, but this is the final spot for air leaks
Adding insulation is just part of an energy efficiency strategy as most insulations do not air seal. Air sealing comes first and is usually more cost effective.
Once you get a tight attic then look to your basement and crawl space. You have the lid on top, now you need to make the bottom air-tight. If you have a crawl space, encapsulation is the way to go. Seal the rim board where floor joists meet the outside wall. Add insulation to the walls and seal it all up tight with a vapor barrier. A crawl space should be conditioned, not vented – making it air-tight also keeps the critters out. If you have a basement, the work is a little different. You want to find any utility penetrations and make sure they are air tight. The rim and sill plates should still be insulated and sealed air tight, but again, it depends on the scope of the renovation and if the space is finished.
Next you should look at any ductwork in unconditioned spaces. Make sure it is air tight because it will pull in unconditioned air from unconditioned spaces and send it all around your home. Using mastic to seal the gaps and cracks is the only way to get them air tight. It is tedious work in an existing house, but will improve your energy efficiency and room comfort. You should not use duct tape, it does not work for this application. If you can also wrap those ducts in insulation it will be a benefit to the comfort of the rooms they supply and contribute to a lower energy bill.
Finally, look at doors, windows, and outlets. Caulk and weatherstrip any gap or crack. Make sure the windows and doors close tight. Take off the outlet covers and seal the box tight to the drywall. Add storm windows if you have single pane windows. Consider replacing old doors with insulated exterior doors.
It is hard to find the biggest leaks in a home, but that is the path to more comfort and lower energy bills. The first step for making a home more comfortable and energy-efficient is to call an energy auditor to get full audit – they will pay for themselves if you act on their findings. While we aren’t official energy auditors, we use professional diagnostic tools like blower doors and thermal cameras during our renovation planning.
Want to know more about making your home efficient and comfortable?
Give us a call today to schedule a consultation!



